TC928R 6 Inch Slope Ceiling Non-IC Remodel Housing for use in slope ceiling applications with a 7/12 to 12/12 pitch (30 to 45 degrees) where the back side of ceiling is not accessible. Installs through an opening in ceiling from below. Adjustable fixture height between 7 3/8 inch minimum to 9 inch maximum. For 2x8 or 2x10 construction. Secures in place with factory supplied remodel clips. Designed for use in non-insulated areas. If installed where insulation is present, the insulation must be pulled back 3 inches from all sides of the housing. Adjustable to position lamp perpendicular to floor. One 120 volt, PAR38, PAR30, BR30, PAR16 or A19 medium base halogen/incandescent or LED equivalent lamp is required, but not included. Halogen and incandescent lamps dimmable using a standard incandescent dimmer. Consult lamp manufacturer for dimmer compatibility when using an LED equivalent lamp. Lamp type and wattage dependent upon housing/trim combination (see attached Juno manufacturer specification). UL listed for through-branch wiring, damp locations and IP. Wet location approved for covered ceiling applications. 14 inch length x 7.4 inch width x 9 inch height. A complete fixture includes a housing and trim, sold separately.
Juno Lighting Inc. is one of the largest manufacturers of recessed and track lighting including Trac-Master®, Trac 12, Flex 12, Trac 12/25, and recessed downlights. Juno was founded in 1976 with the vision of offering high quality lighting fixtures that are attractive, well-engineered and easy to install. Aculux is a comprehensive series of high-performance architectural-grade recessed luminaires. Juno designs, manufactures and markets track, recessed and linear undercabinet / casework lighting products for a broad range of retail, commercial and residential applications.